Lock Cylinder

Can someone give me a step by step on how to replace an ignition lock cylinder?

I have a 1988 Cadillac Deville sedan. I have ordered the part but can not find how to take out the current lock cylinder.

This may or may not help,but i found this

REMOVE OR DISCONNECT

1. Disable the SIR System.
2. Battery negative cable.
3. Knee bolster and IP steering column reinforcement. NOTICE: The steering column should never be supported by only the lower support bracket alone, damage to the column lower bearing adapter could result.
4. Lower support bracket from vehicle (2 bolts).
5. Upper column support from IP (2 bolts).
6. Lower steering column so that it rests on the driver seat.
7. Ignition switch wiring protector.
8. Ignition switch retaining screw and nut.
9. Ignition and turn signal switch column harness connectors from IP harness.
10. Turn signal switch connector from column harness.
11. Ignition switch, harness, and connector. Important

o DO NOT splice ignition switch wires.

INSTALL OR CONNECT

1. Ignition switch, securing with retaining screws.

o Adjust ignition switch. Steering Column Unit Repair.

2. Turn signal switch connector to column harness.
3. Ignition and turn signal switch column harness connectors to IP harness.
4. Ignition switch wiring protector.
5. Raise steering column to support bracket.
6. Two bolts to upper support bracket. Do not tighten fully at this time.
7. Bolt and nut to lower support bracket.

o Align column to instrument panel opening. A small shim (wedge) placed between the instrument panel column support bracket and the column can be used to hold the column stationary while tightening the upper support bolts.
o Upper and lower column support bolts and nuts to 27 Nm (20 ft. lbs.).

8. IP steering column reinforcement plate and knee bolster.
9. Battery negative cable.
10. Enable the SIR system.

How To Install Replace Trunk Lock Cylinder Key Honda Accord 94-97 Prelude 92-96 1AAuto.com

Kegco Standard Homebrew Kegerator Conversion Kit with 5 lb. Co2 Tank – SHCK-5T $119.95 The Standard Homebrew Kegerator Conversion Kit comes with everything you will need to successfully convert your refrigerator into a home brew dispenser. All the draft beer parts are of the highest commercial grade quality which are designed and built to last. The standard kit has a Pro-Line double gauge regulator upgrade over the single gauge regulator found in the economy kit….

Cylinder Airlock $0.99 Three piece plastic airlock….

Homebrew Kegging Kit with Co2 Regulator and Keg (CO2 Tank not included) $156.49 This is the ultimate in homebrew storage and dispensing. You’ll never have to spend so much time bottling again. Learn To Brew’s Homebrew Kegging System holds a complete five gallon batch in one vessel, fits inside a spare refrigerator, eliminates the tedious chore of sanitizing and filling bottles, and makes it possible to force-carbonate your beer so you can enjoy handcrafted draft beer a day or…

Through The Lock: Cylinders and Key Tools $36.50 One of the country’s leading forcible entry specialists, Chief (Ret.) Tom Brennan (1940-2006) shares with you the techniques, equipment, and procedures necessary to carry out the forcible entry operation. This five-part series introduces you to various locking mechanisms and security devices that you may encounter. Chief Brennan discusses safe techniques needed to bypass special locking devices, …

Masterlock Combination Stainless Steel Padlock W/Key Cylinder, 1-7/8 Wide, Black/Silver $2.95 Protect your belongings at home or in the workplace. This combination lock features an easy, dependable 3-number dialing with automatic scrambling to prevent reopening. The double reinforced construction with stainless steel outer case and cold rolled steel inner case make for a tough and strong lock. The nickel plated hardened steel shackle resists rust–ensuring a long life. Equipped with a stan…

Avenir Standard U-Lock and Cable Lock Duo $18.68 Lock your bike and its components securely with the Standard U-Lock and Cable Combo from Avenir. This affordable combo provides both the beefed up security of Avenir’s Standard U-Lock with shackle with pick/pull/drill-resistant cylinder, and the flexibility of the four-foot, coated steel cable. The 4.5 by 9-inch U-Lock is built to last with a rotating dust cover to protect the cylinder and a prote…

Schlage BE365VCAM619 Camelot Keypad Deadbolt, Satin Nickel $109.99 Visual pack. Camelot. For keyed exterior doors. Locked from exterior by rotating keyway or from interior by turning or thumb piece. Deadbolt opened from outside by entering valid user code when rotating keyway turn or by interior thumb turn. Key can be used to unlock as backup. Dual option latch includes: 1/4” round corner and 1” circular drive in latch. Adjustable for 2 3/8” or 2 3/4” backset…

Kryptonite Evolution Series 4 Standard Bicycle U-Lock with Bracket (4-Inch x 9-Inch) $73.99 Kryptonite Series 4 Evolution U-Locks feature a 14mm, hardened MAX-Performance steel shackle with a double deadbolt design.14mm, hardened MAX-Performance steel shackle with double deadbolt designHigh security disc-style cylinder with more than a million key variations, 2 standard and 1 lighted keyReinforced anti-drill/pull cylinder with center key location and overhead cam locking mechanism$2,250 …

The Original InStyler Rotating Hot Iron Hair Straightener $65.00 You can deal with shampoos and conditioners. Professional hair styling can be expensive. You’ve got the insight but you don’t have the proper styling tools. You really don’t need tools. You just need the InStyler…

Daylee Naturals Exfoliating Mesh Soap Saver When you first get the soap saver, it is in a very neat cylinder shape but it easily expands to accept a wide variety of shapes and sizes. Just slip your soaps in and close the top by pulling on the cord. A great little spring loaded stopper will lock it shut. The net mesh has a “crinkle” effect that is wonderful for exfoliating action and you simply hang to dry….